Risk and sizing

Position sizing in trading: a trend follower's guide

By Koen van Goch · Updated

Position sizing is your main lever on how deep drawdowns get, often more than your entry and exit rules. The usual approach in trend following is to risk a small, fixed fraction of the account per trade, scale each position by the stock's volatility so a jumpy stock gets a smaller position, and cap total open risk. Start from the drawdown you can tolerate and work backwards.

Why position sizing matters more than entries

The same entry and exit rules can give a mild ride or a brutal one, depending only on sizing. Trend following has long losing streaks by design. If each loss is too big, a normal streak becomes a drawdown you can't sit through. Sizing is the part of "how much can I lose?" that you control.

Three common position sizing methods

  • Fixed fraction of equity: each position is a fixed percentage of the account, for example 10%. It's simple, but ignores how volatile each stock is.
  • Risk-based (fixed fractional risk): you risk a fixed percentage of the account between entry and stop. Position size = (account × risk %) ÷ (entry − stop).
  • Volatility-based: you size so each position has the same expected daily movement, often using ATR (average true range). Volatile stocks get smaller positions.

Many trend systems combine the last two: the stop is a multiple of ATR, and size is set so that the stop equals a fixed risk percentage.

A worked example (illustration only)

Account: 100,000. Risk per trade: 0.5%, so 500. The stock trades at 50 with an ATR of 2, and the stop is 2 × ATR = 4 below entry. Position size = 500 ÷ 4 = 125 shares, about 6,250 or 6% of the account.

A calmer stock with an ATR of 1 would get 250 shares at the same risk. This is an illustration of the arithmetic, not a recommended risk level.

Portfolio heat and caps

Risk per trade isn't the whole story. With 20 open positions at 0.5% each, you have 10% of the account at risk to your stops, and in a sharp sell-off stocks move together and gaps can blow through stops. Common safeguards:

  • a cap on total open risk ("portfolio heat");
  • a maximum position size as a percentage of equity;
  • a regime filter that stops new entries when the market is in a downtrend.

Work backwards from your drawdown

Write down the deepest drawdown you could sit through. Test your system at several risk levels and look at the worst drawdown and the longest losing streak at each one. Then choose a level where even a bad run, worse than the backtest, stays inside your limit. Live drawdowns are usually deeper than backtested ones. More in how to handle drawdowns, and see how sizing fits into a full trend following strategy.

FAQ

Common questions

How much should I risk per trade?

There's no universal number. It depends on how many positions you hold, how correlated they are and the drawdown you can tolerate. Test several levels and choose the one whose worst realistic drawdown you could live with.

Is ATR-based position sizing better?

For stocks with very different volatility, it usually gives a more even spread of risk than equal-dollar positions. It isn't better in every case, but it stops one jumpy stock from dominating your results.

Should I increase size after a winning streak?

Sizing as a percentage of current equity already grows positions as the account grows. Raising risk percentages after good runs is a common way to turn a normal drawdown into a large one.

What about the Kelly criterion?

Full Kelly is far too aggressive for real trading because your estimates of edge are uncertain. If you use it at all, use a small fraction, and still check the drawdowns.

Does position sizing change my win rate?

No. Sizing changes how much each win and loss is worth, and so it changes your drawdowns and the growth of the account. It doesn't change which trades win.

Not sure your sizing matches your risk tolerance?

That's one of the first things we look at together. Request a free 30-minute introductory call.